Huawei Quidway S6500 Series Command Manual

Command Manual - Security
Quidway S6500 Series Ethernet Switches Chapter 1 802.1x Configuration Commands
Huawei Technologies Proprietary
1-5
Parameter
None
Description
Using dot1x dhcp-launch command, you can set 802.1x to disable the switch to
trigger the user ID authentication over the users who configure static IP addresses in
DHCP environment. Using undo dot1x dhcp-launch command, you can set 802.1x to
enable the switch to trigger the authentication over them.
By default, the switch can trigger the user ID authentication over the users who
configure static IP addresses in DHCP environment.
For the related command, see dot1x.
Example
# Disable the switch to trigger the authentication over the users who configure static IP
addresses in DHCP environment.
[Quidway] dot1x dhcp-launch
1.1.5 dot1x guest-vlan
Syntax
dot1x guest-vlan vlan-id [ interface interface-list ]
undo dot1x guest-vlan vlan-id [ interface interface-list ]
View
System view/Ethernet port view
Parameter
vlan-id: ID of Guest VLAN, ranging from 1 to 4094.
interface_list: Enable the Guest VLAN interface list. interface_list = { interface_type
interface_num | interface_name } [ to { interface_type interface_num |
interface_name } ] &<1-10>. Note that after the key work to, the port number must be
equal to or greater than the port number before to. &<1-10> means the parameter
before it can be input repeatedly for 10 times.
Description
Using the dot1x guest-vlan command, you can enable the Guest VLAN function on
specified port. Using the undo dot1x guest-vlan command, you can disable this
function.

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English