Huawei Quidway S6500 Series - Ospf Cost; Ospf Dr-Priority

Command Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-37
Example
# Set the area 1 where the network segment 131.119.0.0 of Interface Vlan-interface 1 is
located to support MD5 cipher text authentication. The authentication key identifier is
set to 15 and the authentication key is Huawei.
[Quidway-ospf-1] area 1
[Quidway-ospf-1-area-0.0.0.1] network 131.119.0.0 0.0.255.255
[Quidway-ospf-1-area-0.0.0.1] authentication-mode md5
[Quidway-Vlan-interface1] ospf authentication-mode md5 15 Huawei
3.1.34 ospf cost
Syntax
ospf cost value
undo ospf cost
View
Interface view
Parameter
value: Cost for running OSPF protocol, ranging from 1 to 65535.
Description
Using ospf cost command, you can configure different message sending costs so as
to send messages from different interfaces. Using undo ospf cost command, you can
restore the default costs.
For S6500 series switches, the default cost for running OSPF protocol of on the VLAN
interface is 10.
Example
# Specify the cost spent when an interface runs OSPF as 33.
[Quidway] interface Vlan-interface 1
[Quidway-Vlan-interface1] ospf cost 33
3.1.35 ospf dr-priority
Syntax
ospf dr-priority value
undo ospf dr-priority