Command Manual - Security
Quidway S6500 Series Ethernet Switches Chapter 1 802.1x Configuration Commands
Huawei Technologies Proprietary
1-9
interface type, interface-num specifies the interface number and interface-name
specifies the interface name. For the respective meanings and value ranges, read the
Parameter of the Port Command Manual section.
Description
Using dot1x port-method command, you can configure the base for 802.1x to perform
access control on the specified interface. Using undo dot1x port-method command,
you can restore the default access control base.
By default, the value is macbased.
This command is used to set the base for 802.1x to perform access control. When
macbased is adopted, the user access this interface must be authenticated
independently, and if one successful authentication user is to finish network service, the
other accessed users can still use network service. When portbased is adopted, if only
the first access user by this interface can be authenticated successfully, the other
access users followed can be considered authenticated successfully automatically ,but
if the first one finish the network service , the other accessed users’ network service will
be rejected . .
This command has effect on the interface specified by the parameter interface-list
when executed in system view. It has effect on all the interfaces when no interface is
specified. The parameter interface-list cannot be input when the command is executed
in Ethernet Port view and it has effect only on the current interface.
For the related commands, see display dot1x.
Example
# Authenticate the supplicant based on the interface number on Ethernet 3/0/1.
[Quidway] dot1x port-method portbased interface Ethernet 3/0/1
1.1.9 dot1x quiet-period
Command
dot1x quiet-period
undo dot1x quiet-period
View
System view
Parameter
None
To Next Page
Loading...
Need help?
General
