Command Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches
0错误！表格结果无效。
Huawei Technologies Proprietary
1-16
For related commands, see ip route-static and display ip routing-table.
Example
# Delete all the static routes in the router.
[Quidway] delete static-routes all
Are you sure to delete all the unicast static routes?[Y/N]
1.2.2 ip route-static
Syntax
ip route-static ip-address { mask | mask-length } { interface-name | gateway-address }
[ preference preference-value ] [ reject | blackhole ]
undo ip route-static ip-address { mask | mask-length } [ interface-name |
gateway-address ] [ preference preference-value ] [ reject blackhole ]
View
system view
Parameter
ip-address: Destination IP address in dotted decimal notation.
mask: Mask.
mask-length: Mask length. Since "1" s in the 32-bit mask are required to be consecutive,
the mask in dotted decimal format can be replaced by mask-length, which is the
number of the consecutive "1" s in the mask.
interface-name: Specify the interface of the route. The packets that are sent to a NULL
interface, a kind of virtual interface, will be discarded immediately. Thus can decrease
the system load.
gateway-address: Specify the next hop IP address of the route.
preference-value: Preference level of the route in the range from 1 to 255.
reject: Indicate an unreachable route.
blackhole: Indicate a blackhole route.
Description
Using ip route-static command, you can configure a static route. Using undo ip
route-static command, you can delete the configured static route.
By default, the system can obtain the sub-net route directly connected with the router.
When configuring a static route, the default preference is 60. You can change the
default preference value of the static routes to be configured by using the command ip
To Next Page
Loading...
Need help?
General
