Huawei Quidway S6500 Series Command Manual

Command Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches Chapter 2 RIP Configuration Commands
Huawei Technologies Proprietary
2-10
[Quidway-rip] peer 202.38.165.1
2.1.11 preference
Syntax
preference value
undo preference
View
RIP view
Parameter
value: Preference level, ranging from 1 to 255. By default, the value is 100.
Description
Using preference command, you can configure the route preference of RIP. Using
undo preference command, you can restore the default preference.
Every routing protocol has its own preference. Its default value is determined by the
specific routing policy. The preference will finally determine the routing algorithm to
obtain the optimal route in the IP routing table. This command can be used to modify
the RIP preference manually.
Example
# Specify the RIP preference as 20.
[Quidway-rip] preference 20
2.1.12 reset
Syntax
reset
View
RIP view
Parameter
None
Description
Using reset command, you can reset the system configuration parameters of RIP.
When you need to re-configure parameters of RIP, this command can be used to
restore to the default setting.

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English