Huawei Quidway S6500 Series Command Manual

Command Manual - Getting Started
Quidway S6500 Series Ethernet Switches Chapter 1 Logging in Ethernet Switch Commands
Huawei Technologies Proprietary
1-21
Description
Using shell command, you can enable terminal service of a user interface. Using undo
shell command, you can disable the terminal service of a user interface.
By default, terminal service is enabled.
When using the undo shell command, note the following points.
z For the sake of security, the undo shell command can only be used on the user
interfaces other than the AUX user interface.
z You cannot use this command on the user interface via which you log in.
z You will be asked to confirm before executing this command on any legal user
interface.
Example
# Disable terminal service on the vty user interface 0 to 4 after logging in to the Ethernet
switch via user interface 0.
[Quidway] user-interface vty 0 4
[Quidway-ui-vty0-4] undo shell
# The following message will be displayed on the Telnet terminal after logon.
% Disable ui-vty0-4 , are you sure ? [Y/N]
1.1.27 speed
Syntax
speed speed-value
undo speed
View
User interface view
Parameter
speed-value: Specifies the transmission rate on the AUX (Console) port in bit/s, which
can be 300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600 or 115200. The default
rate is 9600bit/s.
Description
Using speed command, you can configure the transmission rate on the AUX (Console)
port. Using undo speed command, you can restore the default rate.
This command can only be performed in AUX user interface view.

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English