Huawei Quidway S6500 Series - Qe Monitor Errpkt Check-Time; Qe Monitor Overflow-Threshold

Command Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 3 Device Management Commands
Huawei Technologies Proprietary
3-14
3.1.18 qe monitor errpkt check-time
Syntax
qe monitor errpkt check-time interval
View
System view
Parameter
interval: Specifies the interval for detecting error packets ranging from 1 to 3600 (in
seconds). It defaults to 5.
Description
Use the qe monitor errpkt check-time command to set the interval for detecting error
packets.
Example
# Set the interval for detecting error packets to 50 seconds.
[Quidway] qe monitor errpkt check-time 50
[Quidway]
3.1.19 qe monitor overflow-threshold
Syntax
qe monitor overflow-threshold threshold
View
System view
Parameter
threshold: An integer that sets the overall traffic threshold, ranging from 0 to
4294967295 bps.
Description
Use the qe monitor overflow-threshold command to specify the overall traffic
threshold used in queue traffic monitoring.
The overall traffic threshold defaults to 50,000,000 bps (50 Mbps).
Upon enabling queue traffic monitoring on a switch, the switch monitors the queue
traffic and relieves blocks in the output queue of its interfaces.
The criterion used to distinguish a block is the queue is full, and the traffic of the
corresponding interface is less than the specified threshold.