Huawei Quidway S6500 Series Command Manual

Command Manual - STP
Quidway S6500 Series Ethernet Switches Chapter 1 MSTP Configuration Commands
Huawei Technologies Proprietary
1-6
1.1.5 instance
Syntax
instance instance-id vlan vlan-list
undo instance instance-id [ vlan vlan-list ]
View
MST region view
Parameter
instance-id: Specifies the spanning tree instance ID, ranging from 0 to 16.
vlan-list: Specifies the VLAN list, ranging from 1 to 4094. The switch may support VLAN
4095, 4096 others, however, they can only be mapped to CIST (Instance 0).
Description
Using instance command, you can map the specified VLAN list to the specified STI.
Using undo instance command, you can cancel the specified VLAN list from the
specified STI, the removed VLAN will then be mapped to the CIST (i.e., the Instance 0).
If no VLAN is specified in the undo command, all the VLANs associated with the
specified STI will be mapped to CIST.
By default, all the VLANs are mapped to CIST, i.e., the Instance 0.
MSTP describes the association between VLANs and STIs with the VLAN mapping
table. You can use this command to configure this table. Every VLAN can be mapped to
an STI as per your configuration.
A VLAN cannot be mapped to different instances at the same time. The latter
configured association will replace the former one.
For the related command, see region-name, revision-level, check
region-configuration , vlan-mapping modulo, active region-configuration .
Example
# Map VLAN 2 to STI 1 3 5.
[Quidway-mst-region] instance 1 vlan 1 3 5
1.1.6 region-name
Syntax
region-name name
undo region-name

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English