Huawei Quidway S6500 Series - Chapter 1 Poe Configuration Commands; Display Poe Interface

Command Manual - PoE
Quidway S6500 Series Ethernet Switches Chapter 1 PoE Configuration Commands
Huawei Technologies Proprietary
1-1
Chapter 1 PoE Configuration Commands
1.1 PoE Configuration Commands
1.1.1 display poe interface
Syntax
display poe interface { interface-name | interface-type interface-num | all }
View
Any view
Parameter
interface-name | interface-type interface-num: Port on the switch; refer to Command
Manual – Port for details.
all: Display the PoE status about all ports on the switch.
Description
Using the display poe interface command, you can view the PoE status of a specific
or all ports on the switch.
Example
# Display the PoE status of the Ethernet port Ethernet3/0/1.
<Quidway> display poe interface ethernet3/0/1
Port power status :searching
Port power mode :signal
Port PD class :0
port power priority :low
Port max power :0 mW
Port current power :0 mW
Port average power :0 mW
Port peak power :0 mW
Port current :0 mA
Port voltage :0.0 V