Huawei Quidway S6500 Series - Ospf Trans-Delay; Peer

Command Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-44
Example
# Specify the retransmit for LSA transmitting between the interface Vlan-interface 1 and
the adjacent routers to 12 seconds.
[Quidway] interface Vlan-interface 1
[Quidway-Vlan-interface1] ospf timer retransmit 12
3.1.43 ospf trans-delay
Syntax
ospf trans-delay value
undo ospf trans-delay
View
Interface view
Parameter
value: Transmitting delay of LSA on an interface. It ranges from 1 to 3600. By default,
the value is 1 second.
Description
Using ospf trans-delay command, you can configure the LSA transmitting delay on an
interface. Using undo ospf trans-delay command, you can restore the default value of
the LSA transmitting delay on an interface.
LSA will age in the "link state database" (LSDB) of the router as time goes by (add 1 for
every second), but it will not age during network transmission. Therefore, it is
necessary to add a period of time set by this command to the aging time of LSA before
transmitting it.
Example
# Specify the trans-delay of transmitting LSA on the interface Vlan-interface 1 as 3
seconds.
[Quidway] interface Vlan-interface 1
[Quidway-Vlan-interface1] ospf trans-delay 3
3.1.44 peer
Syntax
peer ip-address [ dr-priority dr-priority-number ]
undo peer ip-address