Command Manual - PoE
Quidway S6500 Series Ethernet Switches Chapter 1 PoE Configuration Commands
Huawei Technologies Proprietary
1-8
Parameter
slot-num: Slot number.
Description
Using the poe enable slot command, you can enable the PoE feature on a board.
Using the undo poe enable slot command, you can restore the default PoE status on
the board.
By default, the PoE on each board is disabled.
Note:
z Before enabling PoE power supply mode, you need first to ensure that the
remaining power output is not less than the full value required for the board.
Otherwise, do not enable PoE power supply mode.
z After PoE power supply mode is enalbed on a board, the rated power output shall
be reserved for the slot enen when the board is removed from the slot. You need
to release this power output using the undo poe enable slot command.
z If you insert a board where PoE is not supported into the slot for which a rated
power output is reserved, the power output reserved shall be released.
z If you insert a PoE-supported board of another type in the slot for which a rated
power output is reserved, the switch still delivers a power output of the original
value.
Example
# Enable PoE on a board.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] poe enable slot 3
# Disable PoE on the board.
[Quidway] undo poe enable slot 3
1.1.7 poe legacy enable slot
Syntax
poe legacy enable slot slot-num
undo poe legacy enable slot slot-num
View
System view
To Next Page
Loading...
Need help?
General
