Huawei Quidway S6500 Series Command Manual

Command Manual - Port
Quidway S6500 Series Ethernet Switches Chapter 1 Ethernet Port Configuration Commands
Huawei Technologies Proprietary
1-20
interface_num: Specifies the port number.
interface_name: Specifies the port name in the interface_name= interface_type
interface_num format.
For parameter description, refer to the interface command.
Description
Using reset counters interface command, you can reset the statistical information on
the port. and count the related information again on the port for the user.
If the port type and number are not specified when clearing the port information,
information of all ports on the switch will be cleared. If only the port type is specified, all
the information on the ports of this type will be cleared. If both port type and port
number are specified, the information on the designated port will be cleared.
Note that after 802.1X is enabled, the port information cannot be reset.
Example
# Reset statistical information on Ethernet port Ethernet1/0/1.
<Quidway> reset counters interface ethernet1/0/1
1.1.24 shutdown
Syntax
shutdown
undo shutdown
View
Ethernet port view
Parameter
none
Description
Using shutdown command, you can disable the Ethernet port. Using undo shutdown
command, you can enable the Ethernet port.
By default, the Ethernet port is enabled.
Example
# Enable Ethernet port Ethernet1/0/1.
[Quidway-Ethernet1/0/1] undo shutdown

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English