Huawei Quidway S6500 Series Command Manual

Command Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 7 NTP Configuration Commands
Huawei Technologies Proprietary
7-15
This command sets the remote server at ip-address as a peer of the local equipment,
which operates in symmetric active mode. ip-address specifies a host address other
than an IP address of broadcast, multicast, or reference clock. By operating in this
mode, a local device can synchronize and be synchronized by a remote server.
Example
# Configure the local equipment to synchronize or synchronized by a peer at
128.108.22.44. Set the NTP version to 3. The IP address of the NTP packets are taken
from that of Vlan-Interface1.
[Quidway] ntp-service unicast-peer 131.108.22.33 version 3 source-interface
Vlan-Interface 1
7.1.19 ntp-service unicast-server
Syntax
ntp-service unicast-server ip-address [ version number ] [ authentication-keyid
keyid ] [ source-interface { interface-name | interface-type interface-number } ]
[ priority ]
undo ntp-service unicast-server ip-address
View
System view
Parameter
ip-address: Specify the IP address of a remote server.
version: Define NTP version number.
number: NTP version number, ranging from 1 to 3.
authentication-keyid: Define authentication key.
keyid: Key ID used for transmitting messages to a remote server, ranging from 0 to
4294967295.
source-interface: Specify the name of an interface.
interface-name: Specify the interface name. When a local device sends an NTP
message to a peer, the source IP address of the message is taken from the address of
the interface.
interface-type: Specify the interface type and determine an interface together with the
interface-number parameter.
interface-number: Specify the interface number and determine an interface together
with the interface-type parameter.
priority: Designate a server as the first choice.

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English