Huawei Quidway S6500 Series - Rip

Command Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches Chapter 2 RIP Configuration Commands
Huawei Technologies Proprietary
2-11
Example
# Reset the RIP system.
[Quidway-rip] reset
2.1.13 rip
Syntax
rip
undo rip
View
system view
Parameter
none
Description
Using rip command, you can enable the RIP and enter the RIP view. Using undo rip
command, you can disable RIP.
By default, the system does not run RIP.
To enter the RIP view to configure various RIP global parameters, RIP should be
enabled first. Whereas the configuration of parameters related to the interfaces is not
restricted by enabling/disabling RIP.
 Note:
Note that the interface parameters configured previously would be invalid when RIP is
disabled.
Example
# Enable the RIP and enter the RIP view.
[Quidway] rip
[Quidway-rip]