Command Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-20
Cost: 1 State: BackupDR Type: Broadcast
Priority: 1
Designated Router: 10.110.10.1
Backup Designated Router: 10.110.10.2
Timers: Hello 10, Dead 40, Poll 40, Retransmit 5, Transmit Delay 1
Table 3-6 Description of information generated by the command display ospf interface
Field Description
Cost Cost of the interface
State State of the interface state machine
Type Network type of OSPF
Priority Priority of DR for interface election
Designated Router DR on the network in which the interface resides
Backup Designated Router BDR on the network in which the interface resides
OSPF timers, defining as follows:
Hello Interval of hello packet
Dead Interval of dead neighbors
Poll Interval of poll
Timers
Retransmit Interval of retransmitting LSA
Transmit Delay Delay time of transmitting LSA
3.1.20 display ospf lsdb
Syntax
display ospf [ process-id ] [ area-id ] lsdb [ brief | [ asbr | ase | network | nssa |
router | summary ] [ ip-address ] [ originate-router ip-address | self-originate ] ]
View
Any view
Parameter
process-id: Process ID of OSPF, ranging from 1 to 65535. The command is applied to
all current OSPF processes if you do not specify a process ID.
area-id: ID of the OSPF area, which can be a decimal integer or in IP address format.
brief: View brief database information.
asbr: View the database information of summary-Asbr-LSA.
ase: View the database information of AS-external-LSA.