Command Manual - Network Protocol
Quidway S6500 Series Ethernet Switches Chapter 7 IPX Configuration Commands
Huawei Technologies Proprietary
7-18
Parameter
service-type: A 4-byte hexadecimal number ranging from to. 0 indicates all service
types.
name: Specifies the server providing the specified service, a string of 1 to 47
characters.
network.node: Network number and node value of the server. A network number
comprises eight hexadecimal numbers and is in the range 0x1 to 0xFFFFFFFD. A
node address identifies a node in the network; it is 48 bits long and comprises 12
hexadecimal numbers that are separated into three parts by ”-”. The leading 0s can be
omitted when you input network/node numbers.
socket: Comprises four hexadecimal numbers and is in the range 0x1 to 0xFFFF.
hop hops: Number of hops to the server, written in decimal and in the range 1 to 15.
The hop count equal to or exceeding 16 implies that the service is unreachable.
preference: Service preference value in the range 1 to 255, with a smaller number
indicating higher preference. By default, the preference value of the static service
entries is 60 (modifiable); the preference value of the dynamic service entries is fixed
to 500.
all: Deletes all the static service entries.
Description
Using the ipx service command, you can add a static service entry to the server
information table. Using the undo ipx service command, you can delete a static
service entry from the server information table.
Example
# Add a static service entry, setting service type to 4, server name to FileServer,
server network number to 130, node number to 0000-0a0b-abcd, hop count to 1 and
server preference to 60.
[Quidway] ipx service 4 FileServer 130.0000-0a0b-abcd 451 hop 1 preference 60
7.1.24 ipx split-horizon
Syntax
ipx split-horizon
undo ipx split-horizon
View
VLAN interface view
To Next Page
Loading...
Need help?
General
