Huawei Quidway S6500 Series Command Manual

Command Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches Chapter 4 Integrated IS-IS Configuration Commands
Huawei Technologies Proprietary
4-29
Example
# Specify NET as “10.0001.1010.1020.1030.00”, in which the system ID is
“1010.1020.1030”, area ID is “10.0001”.
[Quidway] isis
[Quidway-isis] network-entity 10.0001.1010.1020.1030.00
4.1.34 preference
Syntax
preference value
undo preference
View
IS-IS view
Parameter
value: Specify the preference, ranging from1 to 255. By default, the value is 15.
Description
Using preference command, you can configure the preference of IS-IS protocol. Using
undo preference command, you can restore the default value.
Several dynamic routing protocols could run simultaneously on a router. In this case,
there is an issue of sharing and selecting the routing information among all the routing
protocols. The system sets a preference for each routing protocol. When various
routing protocols find the route to the same destination, the protocol with the higher
preference will take effect.
Example
# Configure the preference of IS-IS as 25.
[Quidway-isis] preference 25
4.1.35 reset isis all
Syntax
reset isis all
View
User view

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English