Huawei Quidway S6500 Series Command Manual

Command Manual - Security
Quidway S6500 Series Ethernet Switches Chapter 2 AAA Configuration Commands
Huawei Technologies Proprietary
2-18
lan-access: Specifies user type to lan-access, which mainly refers to Ethernet
accessing users, 802.1x supplicants for example.
terminal: Authorizes the user to use the terminal service (login from the Console port).
Description
Using service-type command, you can configure a service type for a particular user.
Using undo service-type command, you can cancel the specified service type for the
user.
 Note:
You can use either level or service-type command to specify the level for a local user.
If both of these two commands are used, the latest configuration will take effect.
Example
# Set to provide the lan-access service for the user huawei1.
[Quidway-luser-huawei1] service-type lan-access
2.1.19 state
Syntax
state { active | block }
View
ISP domain view
Local user view
Parameter
active: Configures the current ISP domain (ISP domain view)/current user (local user
view) as being in active state, that is, the system allows the users in the domain (ISP
domain view) or the current user (local user view) to request network service.
block: Configures the current ISP domain (ISP domain view)/current user (local user
view) as being in block state, that is, the system does not allow the users in the domain
(ISP domain view) or the current user (local user view) to request network service.
Description
Using state command, you can configure the state of the current ISP domain/ current
user.
By default, after an ISP domain is created, it is in the active state (in ISP domain view).

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English