Huawei Quidway S6500 Series - Dot1 X Port-Method

Command Manual - Security
Quidway S6500 Series Ethernet Switches Chapter 1 802.1x Configuration Commands
Huawei Technologies Proprietary
1-8
interface-num specifies a single Ethernet interface in the format interface-num =
{ interface-type interface-num | interface-name }, where interface-type specifies the
interface type, interface-num specifies the interface number and interface-name
specifies the interface name. For the respective meanings and value ranges, read the
Parameter of the Port Command Manual section.
Description
Using dot1x port-control command, you can configure the mode for 802.1x to perform
access control on the specified interface. Using undo dot1x port-control command,
you can restore the default access control mode.
By default, the value is auto.
This command is used to set the mode, or the interface state, for 802.1x to perform
access control on the specified interface. This command has effect on the interface
specified by the parameter interface-list when executed in system view. It has effect on
all the interfaces when no interface is specified. The parameter interface-list cannot be
input when the command is executed in Ethernet port view and it has effect only on the
current interface.
For the related commands, see display dot1x.
Example
# Configure the interface Ethernet 3/0/1 to be in unauthorized-force state.
[Quidway] dot1x port-control unauthorized-force interface Ethernet 3/0/1
1.1.8 dot1x port-method
Syntax
dot1x port-method { macbased | portbased } [ interface interface-list ]
undo dot1x port-method [ interface interface-list ]
View
System view/Ethernet Port view
Parameter
macbased: Configures the 802.1x authentication system to perform authentication on
the supplicant based on MAC address.
portbased: Configures the 802.1x authentication system to perform authentication on
the supplicant based on port.
interface interface-list: Ethernet interface list including several Ethernet interfaces,
expressed in the format interface-list = { interface-num [ to interface-num ] } & < 1-10 >.
interface-num specifies a single Ethernet interface in the format interface-num =
{ interface-type interface-num | interface-name }, where interface-type specifies the