Command Manual - Network Protocol
Quidway S6500 Series Ethernet Switches Chapter 7 IPX Configuration Commands
Huawei Technologies Proprietary
7-12
7.1.14 ipx route max-reserve-path
Syntax
ipx route max-reserve-path paths
undo ipx route max-reserve-path
View
System view
Parameter
paths: The maximum number of dynamic routes saved in the device to the same
destination. It is in the range 1 to 255 and defaults to 4.
Description
Using the ipx route max-reserve-path command, you can configure the maximum
number of dynamic routes saved in the device to the same destination. Using the
undo ipx route max-reserve-path command, you can restore the default.
When the number of dynamic routes saved in the device to the same destination
exceeds the specified maximum value, the new dynamic routes are dropped directly
without being added into the routing table. When the configured new value is less than
the old one, the switch, however, does not delete the excessive route entries. These
route entries either time out or are manually deleted.
Example
# Set the maximum number of dynamic routes saved in the device to the same
destination to 200.
[Quidway] ipx route max-reserve-path 200
7.1.15 ipx route-static
Syntax
ipx route-static network network.node [ preference value ] [ tick ticks hop hops ]
undo ipx route-static { network [ network.node ] | all }
View
System view
Parameter
network: Destination network number of an IPX static route. It comprises eight
hexadecimal numbers and is in the range 1 to 0xFFFFFFFE.
To Next Page
Loading...
