Huawei Quidway S6500 Series Command Manual

Command Manual - Network Protocol
Quidway S6500 Series Ethernet Switches Chapter 7 IPX Configuration Commands
Huawei Technologies Proprietary
7-1
Chapter 7 IPX Configuration Commands
7.1 IPX Configuration Commands
7.1.1 display ipx interface
Syntax
display ipx interface [ vlan-interface vlan-id ]
View
Any view
Parameter
vlan-id: Specifies a VLAN interface by specifying its VLAN ID.
Description
Using the display ipx interface command, you can view the IPX information of the
specified VLAN interface.
If no vlan-id is specified, the IPX information of all the IPX-enabled VLAN interfaces is
displayed.
Example
# Display the IPX information of VLAN interface 1.
<Quidway> display ipx interface Vlan-interface 1
Vlan-interface1 is down
IPX address is 1.0020-9c68-448e [down]
SAP is enabled
Split horizon is enabled
Update change only is disabled
Forwarding of IPX type 20 propagation packet is disabled
Delay of this IPX interface, in ticks is 1
SAP GNS response is enabled
RIP packet maximum size is 432 bytes
SAP packet maximum size is 480 bytes
IPX encapsulation is Netware 802.3
0 received, 0 sent
0 bytes received, 0 bytes sent
0 RIP received, 0 RIP sent, 0 RIP discarded
0 RIP specific requests received, 0 RIP specific responses sent

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English