Huawei Quidway S6500 Series Command Manual

Command Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-42
3.1.40 ospf timer hello
Syntax
ospf timer hello seconds
undo ospf timer hello
View
Interface view
Parameter
seconds: Interval in seconds for an interface to transmit hello packet. It ranges from 1 to
255.
Description
Using ospf timer hello command, you can configure the interval for transmitting Hello
messages on an interface. Using undo ospf timer hello command, you can restore
the interval to the default value.
By default, the interval is 10 seconds for an interface of p2p or broadcast type to
transmit Hello messages, and 30 seconds for an interface of nbma or p2mp type.
For the related commands, see ospf timer dead.
Example
# Configure the interval of transmitting Hello messages on the interface Vlan-interface
1 to 20 seconds.
[Quidway] interface Vlan-interface 1
[Quidway-Vlan-interface1] ospf timer hello 20
3.1.41 ospf timer poll
Syntax
ospf timer poll seconds
undo ospf timer poll
View
Interface view
Parameter
seconds: Specifies the poll Hello interval, ranging from 1 to 65535 and measured in
seconds. The default value is 40 seconds.

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English