Command Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches Chapter 5 BGP Configuration Commands
Huawei Technologies Proprietary
5-15
Routes total: 10
Table 5-6 Description of information generated by the command display bgp
routing-table
Field Description
Flags
State flags:
# - valid (valid)
^ - active (selected)
D – damped (discarded)
H – history (history)
I – internal (interior gateway protocol)
S - aggregate suppressed (suppressed)
B - Balance
Dest/Mask Destination address/Mask
Next Hop IP address of next hop
Med
MULTI_EXIT_DISC attribute value, which ranges from 0 to
4294967295
Local-Pref Local preference, which ranges from 0 to 4294967295
Origin attribute of route, which indicates that the route updates its
origin relative to the route originating it from AS. It has three
optional values:
IGP
The route belongs to inside of AS. BGP treats aggregate
route and the route defined by the command network as
inside of AS, and origin type as IGP.
EGP The route is learned from exterior gateway protocol (EGP).
Origin
INC
Short for INCOMPLETE: indicates that the original source
of the route information is unknown (learned by other
methods). BGP sets the origin of the route imported
through other IGP protocols as INCOMPLETE
As-path
AS-path attribute of route, which records all AS areas that the route
passes. With it, route loop can be avoided
5.1.16 display bgp routing-table as-path-acl
Syntax
display bgp routing-table as-path-acl acl-number
View
Any view
To Next Page
Loading...
Need help?
General
