Huawei Quidway S6500 Series Command Manual

Command Manual - STP
Quidway S6500 Series Ethernet Switches Chapter 1 MSTP Configuration Commands
Huawei Technologies Proprietary
1-1
Chapter 1 MSTP Configuration Commands
1.1 MSTP Configuration Commands
1.1.1 active region-configuration
Syntax
active region-configuration
View
MST region view
Parameter
None
Description
Using active region-configuration command, you can activate the configurations of
MST region.
This command is used for manually activate the configurations of MST region.
Configuring the related parameters, especially the VLAN mapping table, of the MST
region, will lead to the recalculation of spanning tree and network topology flapping. To
bate such flapping, MSTP applies the configured parameters and launches
recalculation of the spanning tree only when you activate the configured MST region
parameters or enable MSTP.
After you entered this command, MSTP will apply the MST region parameters you
configured to the system and recalculate the spanning tree.
For the related command, see instance, region-name, revision-level, vlan-mapping
modulo, check region-configuration .
Example
# Manually activate MST region configurations.
[Quidway-mst-region] active region-configuration
1.1.2 check region-configuration
Syntax
check region-configuration

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English