Huawei Quidway S6500 Series Command Manual

Command Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 4 System Maintenance Commands
Huawei Technologies Proprietary
4-11
ping 202.38.160.244 : 56 data bytes
Reply from 202.38.160.244 : bytes=56 sequence=1 ttl=255 time = 1ms
Reply from 202.38.160.244 : bytes=56 sequence=2 ttl=255 time = 2ms
Reply from 202.38.160.244 : bytes=56 sequence=3 ttl=255 time = 1ms
Reply from 202.38.160.244 : bytes=56 sequence=4 ttl=255 time = 3ms
Reply from 202.38.160.244 : bytes=56 sequence=5 ttl=255 time = 2ms
--202.38.160.244 ping statistics--
5 packets transmitted
5 packets received
0% packet loss
round-trip min/avg/max = 1/2/3 ms
4.4.2 tracert
Syntax
tracert [ -a source-ip ] [ -f first-TTL ] [ -m max-TTL ] [ -p port ] [ -q num-packet ] [ -w
timeout ] string
View
Any view
Parameter
-a source-ip: Configure the source IP address used by tracert command.
-f: Configure to verify the -f switch, first-TTL specifies an initial TTL, ranging from 0 to
the maximum TTL.
-m: Configure to verify the -m switch, max-TTL specifies a maximum TTL ,ranging from
0 to 255, and larger than the initial TTL.
-p: Configure to verify the -p switch, port is an integer host port number, ranging from 0
to 65535. Generally, user need not modify this option.
-q: Configure to verify the -q switch, num-packet is an integer specifying the number of
query packets sent, ranging from 0 to 65535.
-w: Configure to verify the -wf switch, timeout is an integer specifying IP packet timeout
in seconds, ranging from 0 to 65535.
srting: The IP address of the destination host or the hostname of the remote system.
Description
Using tracert command, you can check the reachability of network connection and
troubleshoot the network. User can test gateways passed by the packets transmitted
from the host to the destination.
By default, when the parameters are not specified,

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English