Huawei Quidway S6500 Series - Debugging Arp

Command Manual - Network Protocol
Quidway S6500 Series Ethernet Switches Chapter 2 ARP Configuration Commands
Huawei Technologies Proprietary
2-3
View
System view
Parameter
aging-time: Aging time of dynamic ARP aging timer, which is in the range of 1 to 1440
minutes. By default, the aging time is 20 minutes.
Description
Using arp timer aging command, you can configure the dynamic ARP aging timer.
Using undo arp timer aging command, you can restore the default dynamic ARP
aging time.
For the related command, see display arp timer aging.
Example
# Configure the dynamic ARP aging timer to 10 minutes.
[Quidway] arp timer aging 10
2.1.4 debugging arp
Syntax
debugging arp packet
undo debugging arp packet
View
User view
Parameter
packet: ARP packet debugging.
Description
Using debugging arp command, you can enable ARP debugging. Using undo
debugging arp command, you can disable the corresponding ARP debugging.
By default, undo ARP debugging is enabled.
For the related command, see arp static, display arp.
Example
# Enable ARP packet debugging.
<Quidway> debugging arp packet
*Aug 31 10:30:20 2005 C_0.6506r ARP/8/arp_send:Send an ARP Packet, operation :
1