Huawei Quidway S6500 Series - Igmp-Snooping Host-Aging-Time

Command Manual - Multicast Protocol
Quidway S6500 Series Ethernet Switches Chapter 2 IGMP Snooping Configuration Commands
Huawei Technologies Proprietary
2-4
Parameter
enable: Enables IGMP Snooping.
disable: Disables IGMP Snooping; By default, the switch disables IGMP Snooping
feature.
Description
Using igmp-snooping enable command, you can enable/disable IGMP Snooping.
Using igmp-snooping disable command, you can restore the default setting.
Caution:
z IGMP Snooping and GMRP cannot run at the same time. You can check if GMRP is
running, using the display gmrp status command, in any view, before enabling
IGMP Snooping.
z Although layer 2 and layer 3 multicast protocols can run together, they cannot run
on the same VLAN or its corresponding VLAN interface at the same time. For
example, if the layer 2 multicast protocol is enabled on a VLAN, then the layer 3
multicast protocol cannot operate on this VLAN, and vice versa.
z IGMP Snooping functions only when it is enabled both in system view and in VLAN
view.
Example
# Enable IGMP Snooping on VLAN 100
[Quidway] igmp-snooping enable
[Quidway] vlan 100
[Quidway-vlan100] igmp-snooping enable
2.1.5 igmp-snooping host-aging-time
Syntax
igmp-snooping host-aging-time seconds
undo igmp-snooping host-aging-time
View
System view