Huawei Quidway S6500 Series Command Manual

Command Manual - Port
Quidway S6500 Series Ethernet Switches Chapter 1 Ethernet Port Configuration Commands
Huawei Technologies Proprietary
1-10
Example
# Enter the Ethernet1/0/1 port view.
[Quidway] interface ethernet1/0/1
1.1.10 loopback-detection control enable
Syntax
loopback-detection control enable
undo loopback-detection control enable
View
Ethernet port view
Parameter
none
Description
Using loopback-detection control enable command, you can enable loopback
detection control function on a Trunk port or Hybrid port. Using undo
loopback-detection control enable command, you can disable loopback detection
control function on a Trunk port or Hybrid port.
This command sets control over the operating status of the port, when the loopback
detection function is enabled and lookback is found on a Trunk or Hybrid port. When
this function is enabled and loopback is detected on a Trunk or Hybrid port, the system
begins to control the operating status of the port.
When this function is disabled and loopback is found, the system just reports a Trap
message but has no control over the operating status of the Trunk or Hybrid port.
By default, loopback detection controlled function on Trunk or Hybrid port is disabled.
Note that, this command has no effect on Access ports.
Example
# Enable the port loopback detection controlled function.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface ethernet 1/0/1
[Quidway-Ethernet1/0/1] port link-type trunk
[Quidway-Ethernet1/0/1] loopback-detection control enable
[Quidway-Ethernet1/0/1]

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English