Huawei Quidway S6500 Series - Rdram; Reboot

Command Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 3 Device Management Commands
Huawei Technologies Proprietary
3-15
Example
# Set the overall traffic threshold used in queue traffic monitoring to 90 Mbps.
[Quidway] qe monitor overflow-threshold 90000000
[Quidway]
3.1.20 reboot
Syntax
reboot [ slot slot-num ]
View
User view
Parameter
slot-num: Specifies the physical card number.The number ranges from 0 to 6. 0
indicates to reset the SRPU, taking the same effect as resetting the switch system.
Description
Using reboot command, you can reset the whole system or the specified card.
Example
# Reset the switch.
<Quidway> reboot
This command will reboot the system. The current configuration has not been
saved and will be lost if you continue. Continue? [Y/N]
3.1.21 rdram
Syntax
rdram { enable | disable }
View
System view
Parameter
enable: Enable RDRAM (Rambus Dynamic Random Access Memory) of the device.
disable: Disable RDRAM of the device.
Description
Using rdram enable command, you can enable RDRAM of the device.