Huawei Quidway S6500 Series - Rip Split-Horizon; Rip Version

Command Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches Chapter 2 RIP Configuration Commands
Huawei Technologies Proprietary
2-16
[Quidway-Vlan-interface1] undo rip output
2.1.19 rip split-horizon
Syntax
rip split-horizon
undo rip split-horizon
View
Interface view
Parameter
none
Description
Using rip split-horizon command, you can configure an interface to use split horizon
when transmitting RIP packets. Using undo rip split-horizon command, you can
configure an interface not to use split horizon when transmitting RIP packets.
By default, an interface is enabled to use split horizon when transmitting RIP packets.
Normally, split horizon is necessary for reducing route loop. Only in some special cases,
split horizon should be disabled to ensure the correct execution of protocols.
Example
# Specify the interface Vlan-interface 1 not to use split horizon when processing RIP
packets.
[Quidway] interface Vlan-interface 1
[Quidway-Vlan-interface1] undo rip split-horizon
2.1.20 rip version
Syntax
rip version 1
rip version 2 [ broadcast | multicast ]
undo rip version
View
Interface view
Parameter
1: Interface version is RIP-1.