Huawei Quidway S6500 Series - Display Protocol-Vlan Interface; Protocol-Based VLAN Configuration Commands

Command Manual - VLAN
Quidway S6500 Series Ethernet Switches Chapter 1 VLAN Configuration Commands
Huawei Technologies Proprietary
1-8
1.3 Protocol-Based VLAN Configuration Commands
1.3.1 display protocol-vlan interface
Syntax
display protocol-vlan interface { { interface-type interface-number | interface-name }
[ to { interface-type interface-num | interface-name } ] | all }
View
Any view
Parameter
{ interface_type interface_num | interface_name } [ to { interface_type interface_num |
interface_name } ]: Specifies ports. You can specify multiple sequential ports with the to
parameter, instead of specifying only one port. interface_name specifies port name, in
the format of interface_name = interface_type interface_num. interface_type specifies
port type and interface_num port number.
all: Displays the protocol information of all ports.
Description
Using the display protocol-vlan interface command, you can view the protocol
information and protocol index configured on the specific port, to which you can refer
when you use the protocol-based VLAN and add/delete a protocol.
For the related commands, see display interface.
Example
# Display the protocol information and protocol index configured on Ethernet1/0/1 and
Ethernet1/0/2.
[Quidway] display protocol-vlan interface ethernet1/0/1 to ethernet1/0/2
Interface: Ethernet1/0/1
VLAN ID Protocol-Index Protocol-type
50 1 ip 192.168.10.1 255.255.255.0
80 2 ip 101.120.34.0 255.255.0.0
100 1 ip 104.232.43.0 255.255.255.0
100 2 ipx ethernetii
Interface: Ethernet1/0/2
VLAN ID Protocol-Index Protocol-type
50 5 ipx raw
80 1 at
100 3 mode snap etype 0x0abc
100 5 mode llc dsap 0xac ssap 0xbd