Command Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches Chapter 4 Integrated IS-IS Configuration Commands
Huawei Technologies Proprietary
4-16
Parameter
acl-number: ACL number. When configuring routing leak from Level-2 to Level-1, only
the routes that are permitted by ACL can be imported to Level-1 area if an ACL has
been specified.
Description
Using the import-route isis level-2 into level-1 command, you can enable routing
information in a Level-2 area to be imported to a Level-1 area. Using the undo
import-route isis level-2 into level-1 command, you can remove the function.
By default, routing information in a Level-2 area is not imported to a Level-1 area.
For the related commands, see import-route.
Example
# Import routing information of a router from a Level-2 area to a Level-1 area.
[Quidway] acl number 3100 permit any
[Quidway] isis
[Quidway-isis] import-route isis level2 into level1 acl 3100
4.1.18 isis
Syntax
isis [ tag ]
undo isis [ tag ]
View
System view
Parameter
tag: the name given to the ISIS process. The name length should be no longer than 128
characters, and it can be 0, which means null.
Description
Using isis command, you can start the corresponding IS-IS routing process and enter
the ISIS view. Using undo isis command, you can delete the specified IS-IS routing
process.
By default, IS-IS routing process is not started
For the normal operation of the IS-IS protocol, the isis command must be used to
enable the IS-IS process. Then the network-entity command is used to set a Network
Entity Title (NET) for the router. And, at last, the isis enable command is used to
To Next Page
Loading...
Need help?
General
