Huawei Quidway S6500 Series Command Manual

Command Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 7 NTP Configuration Commands
Huawei Technologies Proprietary
7-2
Example
# Enable NTP access control debugging.
<Quidway> debugging ntp-service access
7.1.2 display ntp-service sessions
Syntax
display ntp-service sessions [ verbose ]
View
Any view
Parameter
verbose: Indicate to display the detail information about the sessions.
Description
Using display ntp-service sessions command, you can display the status of all the
sessions maintained by NTP service provided by the local equipment.
When you configure this command without the verbose parameter, the Ethernet switch
will display the brief information about all the sessions it maintains.
With the verbose parameter configured, Ethernet switch will display the detail
information about all the sessions it maintains.
 Note:
All the NTP operating modes create sessions except the NTP Server Mode after the
relevant configuration.
Example
<Quidway> display ntp-service sessions
source refid st now poll reach delay offset disp
********************************************************************
[12345]212.125.95.4 131.188.3.221 2 18 64 377 339.8 10.8 0.9
note: 1 source(master),2 source(peer),3 selected,4 candidate,5 configured
7.1.3 display ntp-service status
Syntax
display ntp-service status

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English