Huawei Quidway S6500 Series - Display Pim Rp-Info

Command Manual - Multicast Protocol
Quidway S6500 Series Ethernet Switches Chapter 5 PIM Configuration Commands
Huawei Technologies Proprietary
5-11
(192.168.1.2, 224.2.178.130),
Protocol 0x20: PIMSM, Flag 0x4: SPT
UpTime: 23:59, Timeout after 196 seconds
Upstream interface: VLAN-interface2, RPF neighbor: NULL
Downstream interface list: NULL
(192.168.1.2, 224.2.181.90),
Protocol 0x20: PIMSM, Flag 0x4: SPT
UpTime: 23:59, Timeout after 196 seconds
Upstream interface: VLAN-interface2, RPF neighbor: NULL
Downstream interface list: NULL
Total 2 entries listed
Table 5-4 Output description about PIM routing table
Field Description
RP Rendezvous Point
(S,G) (source address, multicast group)
PIM-SM PIM Sparse Mode
SPT Shortest Path Tree
RPF Reverse Path Forwarding
5.1.12 display pim rp-info
Syntax
display pim rp-info [ group-address ]
View
Any view
Parameter
group-address: Specifies the group address to display. If no multicast group is specified,
the RP information about all multicast groups will be displayed.
Description
Using display pim rp-info command, you can view the RP information of multicast
group.
In addition, this command can also display the BSR and static RP information.