Huawei Quidway S6500 Series Command Manual

Command Manual - QoS/ACL
Quidway S6500 Series Ethernet Switches Chapter 2 Qos Command
Huawei Technologies Proprietary
2-20
Description
Using the priority command, you can set the priority of the Ethernet interface. Using
the undo priority command, you can resume the default situation.
By default, the priority of port is 0.
This command is used to set the priority of the Ethernet interface. If the received
packets without the mark of “VLAN”, the switch will use the default VLAN of the port
receiving the packets as the VLAN mark of the packets, then the 802.1p priority of the
VLAN mark will be the priority of the receiving port.
Example
# Set the priority level of port Ethernet1/0/1 to 7.
[Quidway-Ethernet1/0/1] priority 7
2.1.17 priority-trust
Syntax
priority-trust { dscp | ip-precedence | cos | local-precedence }
View
System view
Parameter
dscp: Puts the packets into corresponding port output queue according to dscp
priority.
ip-precedence: Puts the packets into corresponding port output queue according to IP
precedence.
cos: Puts the packets into the corresponding port output queue according to 802.1p
priority.
local-precedence: Puts the packets into corresponding port output queue according to
local precedence.
Description
Using the priority-trust command, you can configure the priority by which the switch
puts packets into the port output queue.
By default, the switch chooses the local-precedence.

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English