Command Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches Chapter 5 BGP Configuration Commands
Huawei Technologies Proprietary
5-34
Description
Using peer as-path-acl import command, you can configure filtering Policy of BGP
received routes based on AS path list. Using undo peer as-path-acl import command,
you can cancel the existing configuration.
By default, the peer/peer group has no AS path list.
For the related commands, see peer as-path-acl export.
Example
# Set the AS path ACL of the peer group test to filter BGP received routes.
[Quidway-bgp] peer test as-path-acl 2 import
5.1.38 peer connect-interface
Syntax
peer { group-name | peer-address } connect-interface interface-name
undo peer { group-name | peer-address } connect-interface interface-name
View
BGP view
Parameter
group-name: Specified peer group.
peer-address: IP address of the peer.
interface-name: Interface name.
Description
Using peer connect-interface command, you can specify the source interface of a
route update packet. Using undo peer connect-interface command, you can restore
the best source interface.
By default, BGP uses the best source interface.
Usually, BGP uses the optimal route to update the source interface of the packets.
However, you can set the mode of the interface to Loopback in order to send route
updates even if the interface is not work normally.
Example
# Specify Vlan-interface1 as the source interface of a route update packet.
[Quidway-bgp] peer test connect-interface vlan-interface 1
To Next Page
Loading...
