Command Manual - Multicast Protocol
Quidway S6500 Series Ethernet Switches Chapter 5 PIM Configuration Commands
Huawei Technologies Proprietary
5-19
For the related commands, see reset multicast routing-table, reset multicast
forwarding-table and display pim routing-table.
Example
# Clear the route entries with group address 225.5.4.3 from the PIM routing table.
<Quidway> reset pim neighbor 25.5.4.3
5.1.23 source-policy
Syntax
source-policy acl-number
undo source-policy
View
PIM view
Parameter
acl-number: Basic or advanced ACL, in the range of 2000 to 3999.
Description
Using source-policy command, you can set to filter the source (and group) address of
multicast data packets. Using undo static-rp command, you can remove the
configuration.
If resource address filtering is configured, as well as basic ACLs, then the router filters
the resource addresses of all multicast data packets received. Those not matched will
be discarded.
If resource address filtering is configured, as well as advanced ACLs, then the router
filters the resource and group addresses of all multicast data packets received. Those
not matched will be discarded.
When this feature is configured, the router filters not only multicast data, but the
multicast data encapsulated in the registration packets.
The new configuration overwrites the old one if you run the command for a second
time.
Example
# Set to receive the multicast data packets from source address 10.10.1.2, but discard
those from 10.10.1.1.
[Quidway] multicast routing-enable
[Quidway] pim
[Quidway-pim] source-policy 2000
To Next Page
Loading...
Need help?
General
