Command Manual - Port
Quidway S6500 Series Ethernet Switches Chapter 2 Link Aggregation Configuration Commands
Huawei Technologies Proprietary
2-9
2.1.12 link-aggregation
Syntax
link-aggregation interface_name1 to interface_name2 [ both ]
View
System view
Parameter
interface_name1: Starting range value of Ethernet port joined the Ethernet link
aggregation.
interface_name2: Last range value of Ethernet port joined the Ethernet link
aggregation.
both: Specifies that each member port in the link group performs load sharing for
incoming and outgoing traffic.
Description
Use the link-aggregation command to set a group of ports to be link group with an
auto assigned group number. You can use the ink-aggregation group mode and port
link-aggregation group commands to accomplish this task.
By default, load sharing is carried out:
z Based on IP addresses for IP packets.
z Based on MAC addresses for non-IP packets.
Example
# Add the ports Ethernet1/0/1 through Ethernet1/0/4 to the link group and specify them
to perform load sharing for incoming and outgoing traffic.
[Quidway] link-aggregation ethernet1/0/1 to ethernet1/0/4 both
2.1.13 link-aggregation group description
Syntax
link-aggregation group agg-id description alname
undo link-aggregation group agg-id description
View
System view
Parameter
agg-id: Aggregation group ID, in the range of 1 to 384.
To Next Page
Loading...
