Huawei Quidway S6500 Series Command Manual

Command Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 7 NTP Configuration Commands
Huawei Technologies Proprietary
7-6
7.1.7 ntp-service authentication-keyid
Syntax
ntp-service authentication-keyid number authentication-mode md5 value
undo ntp-service authentication-keyid number
View
System view
Parameter
number: Specify the key number and range from 1 to 4294967295.
value: Specify the value of the key with 1 to 32 ASCII characters.
Description
Using ntp-service authentication-keyid command, you can set NTP authentication
key. Using undo ntp-service authentication-keyid command, you can cancel the
NTP authentication key.
By default, there is no authentication key.
Only MD5 authentication is supported for the NTP authentication key settings.
Example
# Set MD5 authentication key 10 as BetterKey.
[Quidway] ntp-service authentication-keyid 10 authentication-mode md5 BetterKey
7.1.8 ntp-service broadcast-client
Syntax
ntp-service broadcast-client
undo ntp-service broadcast-client
View
VLAN interface view
Parameter
None
Description
Using ntp-service broadcast-client command, you can configure NTP broadcast
client mode. Using undo ntp-service broadcast-client command, you can disable the
NTP broadcast client mode.

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English