Command Manual - Getting Started
Quidway S6500 Series Ethernet Switches Chapter 1 Logging in Ethernet Switch Commands
Huawei Technologies Proprietary
1-23
Description
Using super command, you can enable the user to change to user level from the
current user level. If the user has set the super password [ level level ] { simple |
cipher } password, then user password of the higher level is needed, or the former user
level will not change.
Login users are classified into four levels that correspond to the four command levels
respectively. After users of different levels log in, they can only use commands at the
levels that are equal to or lower than its own level.
For the related commands, see super password, quit.
Example
# change to user level 3 from the current user level.
<Quidway> super 3
Password:
1.1.30 super password
Syntax
super password [ level level ] { simple | cipher } password
undo super password [ level level ]
View
System view
Parameter
level: User level, ranging from 1 to 3. The default value is 3, i.e. do not specify user level.
It means the password to be set is used for entering level 3.
simple: Configure to display password in plain text.
cipher: Configure to display password in encrypted text.
password: If the authentication is in the simple mode, the password must be in plain
text. If the authentication is in the cipher mode, the password can either be in
encrypted text or in plain text. The result is determined by the input. A plain text
password is a sequential character string of no more than 16 digits, for example,
huawei918. The length of an encrypted password must be 24 digits and in encrypted
text, for example, _(TT8F]Y\5SQ=^Q`MAF4<1!!.
Description
Using super password command, you can configure the password for changing the
user from a lower level to a higher level. In order to prevent unauthorized users from
illegal intrusion, user ID authentication is performed when users switch from a lower
To Next Page
Loading...
Need help?
General
