Huawei Quidway S6500 Series Command Manual

Command Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 3 Device Management Commands
Huawei Technologies Proprietary
3-10
Description
Using the display schedule reboot command, you can check the configuration of
related parameters of the switch schedule reboot terminal service.
For the related command, see reboot, schedule reboot at, schedule reboot delay, undo
schedule reboot.
Example
# Display the configuration of the schedule reboot terminal service parameters of the
current switch.
<Quidwa> display schedule reboot
System will reboot at 16:00:00 2002/11/1 (in 2 hours and 5 minutes).
3.1.13 display uplink monitor
Syntax
display uplink monitor
View
Any view
Parameter
None
Description
Use the display uplink monitor command to view information about Layer 3
connectivity between the local device and the remote device.
Related command: uplink monitor.
Example
# View information about Layer 3 connectivity between the local device and the remote
device.
<Quidway> display uplink monitor
UpLink monitor information
No Dest_IP_Addr Dest_MAC_Addr Vlan Port ErrCnt Last_Err_Time
3.1.14 pause-protection
Syntax
pause-protection { enable | disable } slot slot-num

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English