Huawei Quidway S6500 Series Command Manual

Command Manual - STP
Quidway S6500 Series Ethernet Switches
Chapter 4 Rapid Transition Configuration
Commands
Huawei Technologies Proprietary
4-2
Related command: stp no-agreement-check.
 Note:
Configure rapid transition for root port or Alternate port only.
Example
# Enable rapid transition on Ethernet3/0/1 port.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway]stp interface Ethernet3/0/1 no-agreement-check
4.1.2 stp no-agreement-check
Syntax
stp no-agreement-check
undo stp no-agreement-check
View
Ethernet port view
Parameter
None
Description
Use the stp no-agreement-check command to enable rapid transition for the port.
Use the undo stp no-agreement-check command to disable rapid transition on the
port.
Rapid transition is disabled on a port by default.
As switches of certain manufacturers coming with some proprietary protocols
concerning STP employed, the way to implement rapid transition on the designated
ports of this kind of switches is similar to that of RSTP. So, when a switch of this kind
operates as the upstream switch with Quidway series switches running MSTP
connected to it, the upstream designated port fails to change their state rapidly.
Rapid transition is developed for Quidway series switches to avoid this. When Quidway
series switches with MSTP employed are connected to switches of certain
manufacturers, you can enable rapid transition on the ports of the Quidway series
switches operating as the downstream switches. Among these ports, those operating
as the root ports will then send agreement packets to their upstream ports after they

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English