Huawei Quidway S6500 Series - Log-Peer-Change; Md5-Compatible

Command Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches Chapter 4 Integrated IS-IS Configuration Commands
Huawei Technologies Proprietary
4-27
Example
# Set the current router to operate at Level-1.
[Quidway] isis
[Quidway-isis] is-level level-1
4.1.31 log-peer-change
Syntax
log-peer-change
undo log-peer-change
View
IS-IS view
Parameter
none
Description
Using log-peer-change command, you can log the peer changes. Using undo
log-peer-change command, you can configure not to log the peer changes.
By default, peer changes log disabled.
After peer changes log is enabled, the IS-IS peer changes will be output on the
configuration terminal until the log is disabled.
Example
# Configure to output the IS-IS peer changes on the current router.
[Quidway-isis] log-peer-change
4.1.32 md5-compatible
Syntax
md5-compatible
undo md5-compatible
View
IS-IS view
Parameter
none