Command Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches Chapter 5 BGP Configuration Commands
Huawei Technologies Proprietary
5-52
5.1.65 timer
Syntax
timer keep-alive keepalive-interval hold holdtime-interval
undo timer
View
BGP view
Parameter
keepalive-interval: Set the interval time value for keepalive time. The range is 1 to
65535. By default, its value is 60 seconds.
holdtime-interval: Set the interval time value for hold time. The range is 3 to 65535. By
default, its value is 180 seconds.
Description
Using timer command, you can configure the Keep-alive and Hold-time timer of BGP.
Using undo timer command, you can restore the default value of the Keep-alive and
Hold-time of the timer.
Example
# Configure the Keep-alive timer as 30 seconds and Hold-time timer as 90 seconds.
[Quidway-bgp] timer keep-alive 30 hold 90
5.1.66 undo synchronization
Syntax
undo synchronization
View
BGP view
Parameter
none
Description
Using undo synchronization command, you can cancel the synchronization of BGP
and IGP.
By default, BGP doesn’t synchronize with IGP.
If the local BGP is not set synchronous with the IGP and the next hop of the learned
BGP route is reachable, the local BGP will add this BGP route into its routing table