Huawei Quidway S6500 Series Command Manual

Command Manual - Network Protocol
Quidway S6500 Series Ethernet Switches Chapter 5 DHCP Configuration Commands
Huawei Technologies Proprietary
5-2
Description
Use the address-check dhcp-relay enable command to activate the dynamic
entries generated by the DHCP relay.
Use the address-check dhcp-relay disable command to deactivate the dynamic
entries generated by the DHCP relay
By default, the dynamic entries generated by the DHCP relay are activated.
Only when the dynamic entries are activated, the corresponding devices can pass the
DHCP security check.
This configuration takes effect only when the DHCP security feature is enabled on the
VLAN interface.
Example
# Deactivate the dynamic entries generated by the DHCP relay.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface vlan-interface 1
[Quidway-Vlan-interface1] address-check enable
[Quidway-Vlan-interface1] address-check dhcp-relay disable
5.1.3 address-check no-matched
Syntax
address-check no-matched enable
address-check no-matched disable
View
VLAN interface view
Parameter
None
Description
Use the address-check no-matched enable command to inhibit unknown machines
from passing through the DHCP security check.
Use the address-check no-matched disable command to allow unknown machines
to pass through the DHCP security check.
By default, unknown machines are inhibited from passing through the DHCP security
check.

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English