Huawei Quidway S6500 Series Command Manual

Command Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 7 NTP Configuration Commands
Huawei Technologies Proprietary
7-12
Parameter
ip-address: Specify the reference clock IP address as 127.127.t.u. Here, t ranges from
0 to 37 and u ranges from 0 to 3.
stratum: Specify which stratum the local clock is located at and range from 1 to 15.
Description
Using ntp-service refclock-master command, you can configure an external
reference clock or the local clock as an NTP master clock. Using undo ntp-service
refclock-master command, you can cancel the NTP master clock settings.
By default, ip-address is not specified and stratum defaults to 1.
You can use this command to designate an NTP external reference clock or the local
clock as an NTP master clock to provide synchronized time for other equipment.
ip-address specifies the IP address of an external clock as 127.127.t.u. If no IP address
is specified, the local clock is set as the NTP master clock by default. You can also
specify the stratum of the NTP master clock.
Example
# Set the local clock as the NTP master clock to provide synchronized time for its peers
and locate it at stratum 3.
[Quidway] ntp-service refclock-master 3
7.1.16 ntp-service reliable authentication-keyid
Syntax
ntp-service reliable authentication-keyid number
undo ntp-service reliable authentication-keyid number
View
System view
Parameter
number: Specify the key number, ranging from 1 to 4294967295.
Description
Using ntp-service reliable authentication-keyid command, you can configure the
key as reliable. Using undo ntp-service reliable authentication-keyid command,
you can cancel the current setting.
By default, no key is configured as reliable.

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English