Command Manual - Getting Started
Quidway S6500 Series Ethernet Switches Chapter 1 Logging in Ethernet Switch Commands
Huawei Technologies Proprietary
1-8
View
User view
Parameter
type: Specifies the user interface type.
number: Specifies the absolute/relative number of the user interface. Configured
together with the type, it will specify the user interface number of the corresponding
type. If the type is not specified, number will specify an absolute user interface number.
Description
Using free user-interface command, you can clear a user of a specified user interface.
The user interface will be disconnected after the command is executed.
Note that the user of the current user interface cannot be cleared.
Example
# Clear the user of the user interface 1 after logging in to the switch via user interface 0.
<Quidway> free user-interface 1
After the command is executed, user interface 1 will be disconnected. It will not be
connected to the switch until you log in via the user interface 1 for the next time.
1.1.10 header
Syntax
header [ shell | incoming | login ] text
undo header [ shell | incoming | login ]
View
System view
Parameter
login: Login information in case of authentication. It is displayed before the user is
prompted to enter user name and password.
shell: User conversation established header, the information output after user
conversation has been established. If authentication is required, it is prompted after the
user passes authentication.
incoming: Login header, the information output after a Modem user logs in. If
authentication is required, it is prompted after the user passes authentication. In this
case, no shell information is output.
text: Specifies the title text. If you do not choose any keyword in the command, the
system displays the login information by default. The system supports two types of
To Next Page
Loading...
