Huawei Quidway S6500 Series Command Manual

Command Manual - STP
Quidway S6500 Series Ethernet Switches Chapter 1 MSTP Configuration Commands
Huawei Technologies Proprietary
1-28
undo stp [ instance instance-id ] priority
View
System view
Parameter
instance-id: Ranges from 0 to 16.
priority: Specifies the switch priority, ranging from 0 to 61440 with a step length of 4096.
That is, 16 priorities are available for the switch including 0, 4096, 8192, etc. By default,
the switch priority is 32768.
Description
Using stp priority command, you can configure the bridge priority in the specified STI.
Using undo stp priority command, you can restore the default value of bridge priority .
The switch priority takes part in the spanning tree calculation. It is configured separately
for every STI. Different STIs can be configured with different priorities.
If specifying the instance ID as 0, the command can configure the CIST priority.
Example
# Set the bridge priority of the switch in STI 1 to 4096.
[Quidway] stp instance 1 priority 4096
1.1.31 stp region-configuration
Syntax
stp region-configuration
undo stp region-configuration
View
System view
Parameter
None
Description
Using stp region-configuration command, you can enter MST region view. Using
undo stp region-configuration command, you can restore the default MSTP region
configurations.
By default, the three MST region parameters take the default values. The MST region
name of the switch is the first MAC address, all the VLANs are mapped to CIST, and
MSTP revision level takes 0.

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English