Command Manual - Security
Quidway S6500 Series Ethernet Switches Chapter 2 AAA Configuration Commands
Huawei Technologies Proprietary
2-41
When the primary and second servers are all active or block, NAS will send the
packets to the primary server only.
For the related commands, see radius scheme, primary authentication, secondary
authentication, primary accounting, secondary accounting.
Example
# Set the second authentication server of RADIUS scheme, “huawei”, to be active.
[Quidway-radius-huawei] state secondary authentication active
2.2.24 stop-accounting-buffer enable
Syntax
stop-accounting-buffer enable
undo stop-accounting-buffer enable
View
RADIUS scheme view
Parameter
None
Description
Using stop-accounting-buffer enable command, you can configure to save the
stopping accounting requests without response in the switch system buffer. Using
undo stop-accounting-buffer enable command, you can cancel the function of
saving the stopping accounting requests without response in the switch system buffer.
By default, enable to save the stopping accounting requests in the buffer.
Because the stopping accounting request concerns account balance and will affect the
amount of charge, which is very important for both the user and ISP, NAS shall make its
best effort to send the message to RADIUS accounting server. Accordingly, if the
message from the switch to RADIUS accounting server has not been responded, the
switch shall save it in the local buffer and retransmit it until the server responds or
discard the messages after transmitting for specified times.
For the related commands, see reset stop-accounting-buffer, radius scheme,
display stop-accounting-buffer.
Example
# Indicate that, for the RADIUS scheme “Huawei”, the switch will save the stopping
accounting request packets in the buffer
[Quidway-radius-huawei] stop-accounting-buffer enable
To Next Page
Loading...
Need help?
General
