Huawei Quidway S6500 Series Command Manual

Command Manual - Security
Quidway S6500 Series Ethernet Switches Chapter 2 AAA Configuration Commands
Huawei Technologies Proprietary
2-33
View
System view
Parameter
radius-scheme-name: Specifies the Radius server name with a character string not
exceeding 32 characters.
Description
Using radius scheme command, you can configure a RADIUS scheme and enter its
view. Using undo radius scheme command, you can delete the specified RADIUS
scheme.
By default, a RADIUS scheme named as system has been created in the system. Its
attributes are all default values.
RADIUS protocol configuration is performed on a per-RADIUS-scheme basis. Every
RADIUS scheme shall at least have the specified IP address and UDP port number of
the RADIUS authentication/authorization/accounting server and some necessary
parameters exchanged with the RADIUS client end (switch system). So it is necessary
to create the RADIUS scheme and enter its view before performing other RADIUS
protocol configurations.
A RADIUS scheme can be used by several ISP domains at the same time. You can
configure up to 16 RADIUS server-groups, including the default scheme named as
system.
Although undo radius scheme can remove a specified RADIUS scheme. However,
the default one cannot be removed. Note that a scheme currently in use by the online
user cannot be removed.
For the related commands, see key, retry realtime-accounting, radius-scheme,
timer realtime-accounting, stop-accounting-buffer enable, retry stop-accounting,
server-type, state, user-name-format, retry , display radius, display radius
statistics .
Example
# Create a RADIUS scheme named “huawei” and enters its view.
[Quidway] radius scheme huawei
[Quidway-radius-huawei]
2.2.15 reset radius statistics
Syntax
reset radius statistics

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English